|
GDC - Grout
Haze Remover
-
Use
to remove excess grout haze from tile & grout, seven days after
installation of tile. Sold as concentrate in 8 ounce bottle, just
add haze remover to two gallons of water and let stand for about 5
minutes so product can dwell, don not allow to dry. Apply to tiled
area scrub floor with a stiff nylon brush. Then rinse floor with
water and mop up excess. Use to remove Grout Haze Residual and
also to remove organic dirt from grout and to slightly etch the
grout and open the grout pours.
Just
add our GDC Liquid Grout Haze Remover to your two gallon bucket of
water. This product is sold in an 8 ounce bottle, but when mixed
with your cleaning water this solution covers up to 200 square feet
Do not
use on Natural Stone Tiles, such as Marble, Tumbled or Polished
Marble, Granite, Honed or Polished, Terra cotta, and other natural
surfaces.
Do not
let this acidic product come into contact with metal surfaces such as
Stainless Steel , Brass, Copper, Bronze, Zinc, such as Sinks,
Fixtures, Tubs etc.
Do not
discard waste water in sink if it is Stainless Steel , Brass, Copper,
Bronze, Zinc, such as Sinks, Fixtures, Tubs etc.
CAUTION
-
Keep
out of reach of children
-
Do
not take internally
-
Avoid
contact with eyes
-
Gloves
and eye protection should be worn during application
-
IF
INGESTED: Drink 1 to 2 glasses of water. If symptoms persist, seek
medical attention
-
EYE
AND SKIN CONTACT: Flush thoroughly with water. If irritation
persists, seek medical attention
-
Always
do a test area first, wait 1 hour for results
-
Close
container after each use
-
For
best results, do not store in direct sunlight or in temperatures
above 110° F (43° C)
-
Use
in temperatures between 50 and 80° F (10 and 27° C)
|
|
All
rights reserved Copyright 1995 www.tile-grout.net
Grout stain, grout colorant, grout
cleaner, grout paint, groutdye, change grout color, recolor your grout,
grout recoloring, grout, grout sealer, seal grout, epoxy grout stain
colorants.
|
|
